Оптические энкодеры для металлических микро мотор-редукторов (Extended Version - моторы имеющие обратный вал). Набор состоит из двух датчиков, двух 3-х зубчатых колес обеспечивающих 12 импульсов на оборот и двух 5-зубчатых колес, дающие 20 импульсов на оборот. Эта версия предназначена для использования при 5 В.
Add quadrature encoders to your micro metal gearmotors (extended back shaft version required) with this kit consisting of two sensor boards, two 3-tooth encoder wheels, and two 5-tooth encoder wheels. The installed system does not exceed the 12 mm ? 10 mm cross section of the motors and extends only 5 mm beyond the plastic motor end cap. The 3-tooth wheel provides 12 counts per revolution; using the 5-tooth wheel yields 20 counts per revolution. This version is intended for use at 5 V.
Pinout and Installation
The encoder board is designed to be soldered directly to the back of the motor, with the back shaft of the motor protruding through the hole in the middle of the circuit board. The better aligned the board, the better the output signal quality will be. One way to achieve good alignment is to tack down the board to one motor pin and to solder the other pin only when the board is well aligned. Be careful to avoid prolonged heating of the motor pins, which could deform the plastic end cap of the motor or the motor brushes. Once the board is soldered down to the two terminals, the motor leads are connected to the M1 and M2 pads along the edge of the board, along with the power for the sensors and the two quadrature outputs.
Датчики, дисплеи Optical Encoder Pair Kit for Micro Metal Gearmotors. 5V. Описание в формате PDFДатчики, дисплеи Optical Encoder Pair Kit for Micro Metal Gearmotors. 5V. Описание в формате PDF